Part
Control Board
Product Rating
Customer
William from NC
Problem
Burning smell from unit. Fan motor not running.
Tools
Screwdriver, wire stripper, wire crimper
Repair & Advice
Found a push-on terminal connector on the fan wiring connection to board burned up due to poor contact with the terminal on the circuit board. Heating, caused by resistance at terminal, damaged the original circuit board causing it to burn up causing the bad smell. Replaced circuit board and bad terminal. Most difficult part was getting the control panel wiring disconnected and routing the new control panel wiring in the unit.
Story submitted on July 9, 2019
Part
Control Board
Product Rating
Customer
RICHARD from MS
Problem
Fan motor would not turn off.
Tools
Screwdriver , volt/ohm meter , needle nose pliers.
Repair & Advice
The cause of the problem was a burnt-out relay on the control board. the fix was to replace the board.
Story submitted on June 19, 2020
Part
Control Board
Product Rating
Customer
Ray from TX
Problem
Board fried
Tools
Needle nose, screw driver, pencil, phone camera
Repair & Advice
Relatively simple, just keep up with where all the wires go
Story submitted on April 10, 2023