Part
Nozzle Elbow
Product Rating
Customer
Merlion from OR
Problem
Nozzle elbow was cut. Thus water from washing machine inlet was leaking.
Tools
Screwdriver
Repair & Advice
very simple steps from removing a few screws from the top cover and panel than the valve module, remove the cut nozzle and fit in the new one.
Story submitted on March 8, 2023
Part
Nozzle Elbow
Product Rating
Customer
Charles from OH
Problem
Inlet water nozzle was worn out and crumbling
Tools
Screw Driver
Repair & Advice
This was a very easy repair. Simply removed the two top screws of the washing machine to allow access tot he water nozzle at the back. Swapped it out.
Story submitted on January 11, 2024
Part
Nozzle Elbow
Product Rating
Customer
John from FL
Problem
#PD00056557 Fisher & Paykel Fill Spray Nozzle need replacement and elbow was brittle
Tools
screwdriver
Repair & Advice
I decided to replace the Elbow which was brittle when I replaced a failed nozzle. I had difficulty finding any instructions but figured it out. In addition to releasing the lid to get at underneath you will need to remove the top cover and remove the inlet valves to get at the elbow top. You kinda wiggle through the hole but cannot do so with the inlet valve attached. Please note that there will be some water in the tubing and it could short the circuit board so keep rags handy and keep drying area especially before you tilt the top with the inlet valve removed. Other than that pretty easy.
Story submitted on April 1, 2022