Part
Gas Burner Valve Assembly
Product Rating
Customer
Andrew from IL
Problem
The solenoid valve in the burner went out.
Tools
Impact driver, screwdrivers, crescent wrenches.
Repair & Advice
If you go to replace the burner assembly, don't take apart the whole dryer like the videos show, just stick your arm in and pay attention, it's not as hard as videos make it seem.
Story submitted on April 21, 2020
Part
Gas Burner Valve Assembly
Product Rating
Customer
Jeramy from OK
Problem
Heater assembly and Therm-o solenoid replaced.
Tools
1/4 mini open end wrench. Channel locks, adjustable wrench. Stub screwdriver.
Repair & Advice
Easy repair!
Story submitted on February 9, 2021
Part
Gas Burner Valve Assembly
Product Rating
Customer
Howard from IN
Problem
The Gas Dryer would ignite but no gas would be coming out to get the Gas Burner to ignite the flame.
Tools
I used a mini ratchet with 1/4 socket
Repair & Advice
I did purchase the Gas Burner Valve by it's self but when I couldn't get the gas line off the old gas burner value I sent it back. I remember reading that it would be much easier if you get the Gas Burner Value Assembly all in one with the bracket already connected and a new igniter. I purchased it and that was the best and easy solutions to my problem, Plus it came a day sooner then expected. I was told that you don't touch the igniter in any way with your hands keeping oils from your hands to get on the igniter plus you didn't want to bump it or brake it trying to install it. So I practice putting the gas burner in place without bumping it if the igniter was attached in place. I attached the igniter on and put the gas burner valve in place with no issues or problem. Assemble everything back on the dryer and started the dryer and everything work properly and I did my Happy Dance!!!
Story submitted on November 11, 2021