Part
Gas Valve Coil Set
Product Rating
Customer
karl from WA
Problem
Dryer not heating after first startup (flame goes out as seen from view port, small square plug on front panel); initilly gets hot then after few minutes gas shuts down
Tools
1/4, 5/16 sockets, slot and Phillips screwdriver, needle nose pliers, vacuum/duct brush
Repair & Advice
Dryer not heating after first cycle; replaced flame control and igniter, cleaned all ducts etc. replaced belt/idler/wheels; same symptoms..replace valve coils = repaired...thank you
Story submitted on June 20, 2015
Part
Gas Valve Coil Set
Product Rating
Customer
Mordechai from NY
Problem
Dryer would only heat up first cycle and refuse to ignite again
Tools
Putty knife, socket set, screw driver
Repair & Advice
Used the putty knife to push in clips to remove dryer top, socket set to remove front panel, screwdriver to remove gas valve bracket. When removing the 3 pronged valve make sure the washer stays on the receptacle as it does not come with the replacement.
Story submitted on April 5, 2016
Part
Gas Valve Coil Set
Product Rating
Customer
JEFF from KS
Problem
No heat from gas dryer
Tools
Screwdriver, flashlight, volt ohm meter
Repair & Advice
Googled issues, learned specific items to check with volt meter. Had continuity on everything but one gas valve coil. Parts Dr had parts and super quick to receive. Fixed it and running again with heat.
Story submitted on August 12, 2015