Part
Water Inlet Valve
Product Rating
Customer
John from GA
Problem
Water coming into the washer wouldn't stop
Tools
Pliers & screwdriver
Repair & Advice
Unplug from the wall. I had the water cut off at the valve. So it was only removing the top of the washer ( four screws ) . Unplug clips, remove the old one and install the new one. Reconnect clips, connect hoses, and power. Try the new valve. Once all checks out install the cover.
Story submitted on January 27, 2019
Part
Water Inlet Valve
Product Rating
Customer
Cindy from WV
Problem
Water inlet valve cracked
Tools
Screwdriver, adjustable wrench
Repair & Advice
I had to disconnect the water supply lines for both hot and cold, take the back off the washer, disconnect the wiring from the damaged water inlet valve and remove the screws holding it in place, removed damaged valve, removed rubber gaskets from old water inlet valve and put on new valve and placed into water inlet sockets on machine, replaced screws, reconnected wiring, replaced the back on washer, and reconnected water lines. 30 minutes and done! Oh and I'm a girl :) #girlpower
Story submitted on February 13, 2019
Part
Water Inlet Valve
Product Rating
Customer
Kai from NM
Problem
Water inlet valve froze
Tools
screwdriver, pliers
Repair & Advice
The only hard part was reaching one of the srews on the inlet valve - its very hard to reach and almost impossible to see.
Story submitted on March 27, 2022