Water Inlet

Water Inlet

Robert from WI

Watertap error.

Pliers.

There was debris clogging the existing valve which caused the watertap every time we started the dishwasher, but when we restarted it always worked. Turns out you can actually remove the little plastic filters in the inlet and clean it so we may not have needed the part, but replacing it resolved the issue.

Water Inlet

Adam from UT

E15 error caused by bad gasket on sump. Noticed that the water inlet was very dirty when pulling out the machine so replaced alongside sump.

Pliers and screwdriver is all that is needed to replace this part.

This is easy to replace just requires pulling the dishwasher out to access. Use the handle of a pair of pliers to loosen the threaded out let on the inside of the dishwasher. On the side you will need a pair of pliers to move the spring clamp down on the inlet hose, it will be very tight to remove so use a flat head screwdriver to loosen the hose and allow you to pull it off. Be careful not to damage the hose. Once the part is off everything reinstalls easily in reverse order.