Part
Display Module
Product Rating
Customer
Monica from CA
Problem
Display kept shorting out.
Tools
Screw driver.
Repair & Advice
Besure to turn off the electricity first, once that is done we pulled out the oven enough to access the display panel. There are many screws to remove and one electrical connection. Not very hard to replace. Take your time but it was not hard to replace at all.
Story submitted on May 28, 2020
Part
Display Module
Product Rating
Customer
Tim from CO
Problem
display module was inoperative. It self-reset regularly and in the end was non-functional (curser blinking in upper left corner)
Tools
Torq and Philips screwdrivers
Repair & Advice
Turn off the power. Remove oven (oven + microwave) from the wall. These are heavy items and support is recommended. I built a small table that fit under the oven. Remove microwave from the top of the oven. Remove top cover from the oven. Remove front panel from oven. Disconnect ribbon cable and exchange module (note: cable connected to the lower pins on the module). Reassemble. Keep track of all the screws that have been removed – marking the sheet metal with the type of screw is helpful. Insert back into the wall and turn the power back on.
Story submitted on November 22, 2023