Part
Turbidity Sensor
Product Rating
Customer
David from UT
Problem
The Cycle would reset afte a few inital minutes running, and reset the time for 210 minutes for any cycle started.
Tools
Torx driver, towels and Silicone grease
Repair & Advice
Shut power off at breaker. Took the dishwasher out of it's hole under the counter. Undid the door springs, and the screws holding the dishwasher to the plastic undertray. Tilted the dishwasher on its side, and unscrewed the two Torx screws holding the Turbidity Sensor in it's place, disconnected the wire harness to the Sensor, pulled the Sensor. Placed the harness on the new Sensor, added a thin coating of silicone grease to the rubber gasket, and re-installed in the cavity for the Sensor. Replaced the screws, and tipped the dishwasher back upright. Resecured the plastic undertray screws, and slid the dishwasher back into it's place under the counter. Restored the power, and tested the cycle.
Story submitted on November 15, 2023