Part
Main Control Board
Product Rating
Customer
Catharine from NC
Problem
Our dryer stopped working and showed us an error code. Using our owners manual and resources on the internet, we diagnosed it as needing this control board.
Tools
Phillips screwdriver.
Repair & Advice
Very simple repair, just remove a few screws at the top of the drier in back to remove top control panel and you'll see the circuit board. Note where all of the wires are plugged in and put the new one in the same way.
Story submitted on February 10, 2018
Part
Main Control Board
Product Rating
Customer
Richard from PA
Problem
F1 error code on Kenmore Oasis gas dryer.
Tools
Screwdrivers
Repair & Advice
Watched a video about this repair and installed the part in approx. 20 minutes. Up and running fine once again. Worst part was trying to unplug some of the connections on the old control board.
Story submitted on October 9, 2018
Part
Main Control Board
Product Rating
Customer
Robert from GA
Problem
Dryer had power, but would not run.
Tools
Screwdriver, nut driver, pliers.
Repair & Advice
I read through the diagnostic steps included in the original paperwork. Then I ran the diagnostic test and the conclusion was that the machine control circuit board was faulty. I followed the directions, which were accurate and simple, for removing the board. When I had the board out I was able to see a burned place at the motor relay switch. I found the part online, ordered it, and installed it. The dryer works now.
Story submitted on January 23, 2023