- Thermistor Control
CustomerCraig from KS
Dryer wouldn't dry just said sensing
1/4" nut driver, flashlight, needle nosed pilers, 1/4" open ended wrench
Repair & Advice
1. Unplug machine 2. use nut driver to take off the front shield 3. locate the thermistor Control and unplug the wires. use a 1/4 inch wrench and loosen the bolts and remove the thermistor control. Install new thermistor control and tighten the bolts back into place. Plug the wires back into the thermistor control. 4. Plug machine back in and test to see if that fixed your problem. If it did then install the front shield and use dryer.