Part
Control Board
Product Rating
Customer
Bryan from CA
Problem
Washer would not complete rinse cycle.
Tools
Screwdriver (phillips and hex).
Repair & Advice
To replace the control board, all I had to do was take the front door panel off of the washer, remove the control board housing and replace the new control board. It took about 20 minutes and the washer worked like after the repair. Highly recommended if you have control panel issues.
Story submitted on August 18, 2020
Part
Control Board
Product Rating
Customer
Doug from IN
Problem
Random PF Error Code.
Tools
Screwdriver.
Repair & Advice
We would receive a random PF error on the dishwasher at times in the middle of the wash cycle. I read that it was probably the main control board. I bought this and replaced it without any problems. It was fast and easy to do. It has only been installed for a few weeks, but we have not received this fault since I replaced it.
Story submitted on January 27, 2021
Part
Control Board
Product Rating
Customer
Eetu from SC
Problem
Washer gave power errors ("PF" on screen) while running a program, also it sometimes started pumping when closing the door even though the washer was supposed to be off.
Tools
Screwdrivers.
Repair & Advice
Make sure the power is disconnected (I turned off the fuse). Remove the front "skin" of the door (unscrew the screws on the sealing side of the door and slide the skin upwards). After that you get to the control assembly with the control buttons and also the control board. You can access the control board inside the black plastic compartment by undoing the couple screws. Disconnect the electrical connections to the control board and remove the board by undoing few screws. Make sure the connections are identical between old and new part before installing or trying to connect the new part!
I also used this as an opportunity to properly clean the stainless steel parts and the little crevices around the control button assembly. I replaced the board few weeks ago and the washer has worked flawlessly since then.
Story submitted on January 23, 2021